cisco unified cm administration password

Here is the procedure taken straight out of the VCS Admin guide. The process is actually very simple, but requires console access. After that time you will have to restart the system again to change the password. The pwrec account is only active for one minute following a restart. Select the account (root or admin) whose password you want to change.Ħ. Setting to Both this will allow local administrator accounts to access the system.ĥ. If the administrator account authentication source is set to Remote, you are given the option to change the

We strongly recommend that you set a password for the admin user, and to any other user. Log in from the PC with the username pwrec. Contents Introduction Endpoint configuration CUCM configuration. Connect a PC to the VCS using the serial cable as per the instructions in VCS Getting Started Guide.įront Serial port / console access is always enabled for one minute following a restart, even if it is normally disabled.ģ. If you have forgotten the password for either the admin account or the root account, you can reset it using the following procedure:ġ. Resetting your root or admin password via a serial connection If this is not possible you can reset the admin or root password via a serial connection. You can reset any account password by logging in to the VCS as the default admin account or as any other administrator account that has read-write access. The settings below should be used for the console connection: Connection should be made to the data port on the front of the appliance.

To collect logs or other information when there are network problems or other issue preventing access to the Cisco VCS/Conductor remotely, a serial console may be used. The Administrator Account user name must start with an alphabetic character, must be at least six characters long and can contain alphanumeric characters, hyphens and underscores. Secure and scalable, learn how Cisco Meraki enterprise networks simply work. This is based on X7.2 software, assuming your software is older but should be the same. It is used for the login on Cisco Unified OS Administration, Disaster Recovery System pages and Command Line Interface (CLI) login. Cisco Meraki is the leader in cloud controlled Wi-Fi, routing, and security.

Cisco unified cm administration password